#include <rte_memcpy.h>
#include <rte_memzone.h>
#include <rte_eal.h>
-#include <rte_per_lcore.h>
#include <rte_launch.h>
#include <rte_atomic.h>
#include <rte_cycles.h>
struct rte_mempool *pool;
struct rte_lpm *lpm;
struct rte_lpm6 *lpm6;
- uint8_t portid;
+ uint16_t portid;
};
struct tx_lcore_stat {
* send burst of packets on an output interface.
*/
static inline uint32_t
-send_burst(struct lcore_queue_conf *qconf, uint32_t thresh, uint8_t port)
+send_burst(struct lcore_queue_conf *qconf, uint32_t thresh, uint16_t port)
{
uint32_t fill, len, k, n;
struct mbuf_table *txmb;
/* Enqueue a single packet, and send burst if queue is filled */
static inline int
-send_single_packet(struct rte_mbuf *m, uint8_t port)
+send_single_packet(struct rte_mbuf *m, uint16_t port)
{
uint32_t fill, lcore_id, len;
struct lcore_queue_conf *qconf;
}
static inline void
-reassemble(struct rte_mbuf *m, uint8_t portid, uint32_t queue,
+reassemble(struct rte_mbuf *m, uint16_t portid, uint32_t queue,
struct lcore_queue_conf *qconf, uint64_t tms)
{
struct ether_hdr *eth_hdr;
struct rx_queue *rxq;
void *d_addr_bytes;
uint32_t next_hop;
- uint8_t dst_port;
+ uint16_t dst_port;
rxq = &qconf->rx_queue_list[queue];
unsigned lcore_id;
uint64_t diff_tsc, cur_tsc, prev_tsc;
int i, j, nb_rx;
- uint8_t portid;
+ uint16_t portid;
struct lcore_queue_conf *qconf;
const uint64_t drain_tsc = (rte_get_tsc_hz() + US_PER_S - 1) / US_PER_S * BURST_TX_DRAIN_US;
for (i = 0; i < qconf->n_rx_queue; i++) {
portid = qconf->rx_queue_list[i].portid;
- RTE_LOG(INFO, IP_RSMBL, " -- lcoreid=%u portid=%hhu\n", lcore_id,
+ RTE_LOG(INFO, IP_RSMBL, " -- lcoreid=%u portid=%u\n", lcore_id,
portid);
}
/* Check the link status of all ports in up to 9s, and print them finally */
static void
-check_all_ports_link_status(uint8_t port_num, uint32_t port_mask)
+check_all_ports_link_status(uint16_t port_num, uint32_t port_mask)
{
#define CHECK_INTERVAL 100 /* 100ms */
#define MAX_CHECK_TIME 90 /* 9s (90 * 100ms) in total */
- uint8_t portid, count, all_ports_up, print_flag = 0;
+ uint16_t portid;
+ uint8_t count, all_ports_up, print_flag = 0;
struct rte_eth_link link;
printf("\nChecking link status");
/* print link status if flag set */
if (print_flag == 1) {
if (link.link_status)
- printf("Port %d Link Up - speed %u "
- "Mbps - %s\n", (uint8_t)portid,
- (unsigned)link.link_speed,
+ printf(
+ "Port%d Link Up. Speed %u Mbps - %s\n",
+ portid, link.link_speed,
(link.link_duplex == ETH_LINK_FULL_DUPLEX) ?
("full-duplex") : ("half-duplex\n"));
else
- printf("Port %d Link Down\n",
- (uint8_t)portid);
+ printf("Port %d Link Down\n", portid);
continue;
}
/* clear all_ports_up flag if any link down */
nb_mbuf = RTE_MAX(max_flow_num, 2UL * MAX_PKT_BURST) * MAX_FRAG_NUM;
nb_mbuf *= (port_conf.rxmode.max_rx_pkt_len + BUF_SIZE - 1) / BUF_SIZE;
nb_mbuf *= 2; /* ipv4 and ipv6 */
- nb_mbuf += RTE_TEST_RX_DESC_DEFAULT + RTE_TEST_TX_DESC_DEFAULT;
+ nb_mbuf += nb_rxd + nb_txd;
nb_mbuf = RTE_MAX(nb_mbuf, (uint32_t)NB_MBUF);
qconf = &lcore_queue_conf[lcore];
for (i = 0; i < qconf->n_rx_queue; i++) {
- fprintf(stdout, " -- lcoreid=%u portid=%hhu "
+ fprintf(stdout, " -- lcoreid=%u portid=%u "
"frag tbl stat:\n",
lcore, qconf->rx_queue_list[i].portid);
rte_ip_frag_table_statistics_dump(stdout,
uint16_t queueid;
unsigned lcore_id = 0, rx_lcore_id = 0;
uint32_t n_tx_queue, nb_lcores;
- uint8_t portid;
+ uint16_t portid;
/* init EAL */
ret = rte_eal_init(argc, argv);
qconf = &lcore_queue_conf[rx_lcore_id];
+ /* limit the frame size to the maximum supported by NIC */
+ rte_eth_dev_info_get(portid, &dev_info);
+ port_conf.rxmode.max_rx_pkt_len = RTE_MIN(
+ dev_info.max_rx_pktlen, port_conf.rxmode.max_rx_pkt_len);
+
/* get the lcore_id for this port */
while (rte_lcore_is_enabled(rx_lcore_id) == 0 ||
qconf->n_rx_queue == (unsigned)rx_queue_per_lcore) {
rxq->portid = portid;
rxq->lpm = socket_lpm[socket];
rxq->lpm6 = socket_lpm6[socket];
+
+ ret = rte_eth_dev_adjust_nb_rx_tx_desc(portid, &nb_rxd,
+ &nb_txd);
+ if (ret < 0)
+ rte_exit(EXIT_FAILURE,
+ "Cannot adjust number of descriptors: err=%d, port=%d\n",
+ ret, portid);
+
if (setup_queue_tbl(rxq, rx_lcore_id, queueid) < 0)
rte_exit(EXIT_FAILURE, "Failed to set up queue table\n");
qconf->n_rx_queue++;
printf("txq=%u,%d,%d ", lcore_id, queueid, socket);
fflush(stdout);
- rte_eth_dev_info_get(portid, &dev_info);
txconf = &dev_info.default_txconf;
txconf->txq_flags = 0;
if (init_routing_table() < 0)
rte_exit(EXIT_FAILURE, "Cannot init routing table\n");
- check_all_ports_link_status((uint8_t)nb_ports, enabled_port_mask);
+ check_all_ports_link_status(nb_ports, enabled_port_mask);
signal(SIGUSR1, signal_handler);
signal(SIGTERM, signal_handler);