#include <rte_memcpy.h>
#include <rte_memzone.h>
#include <rte_eal.h>
-#include <rte_per_lcore.h>
#include <rte_launch.h>
#include <rte_atomic.h>
#include <rte_cycles.h>
#include <rte_debug.h>
#include <rte_ether.h>
#include <rte_ethdev.h>
-#include <rte_ring.h>
#include <rte_mempool.h>
#include <rte_mbuf.h>
#include <rte_malloc.h>
.hw_ip_checksum = 1, /**< IP checksum offload enabled */
.hw_vlan_filter = 0, /**< VLAN filtering disabled */
.jumbo_frame = 1, /**< Jumbo Frame Support disabled */
- .hw_strip_crc = 0, /**< CRC stripped by hardware */
+ .hw_strip_crc = 1, /**< CRC stripped by hardware */
},
.rx_adv_conf = {
.rss_conf = {
struct rte_ip_frag_death_row *dr;
struct rx_queue *rxq;
void *d_addr_bytes;
- uint8_t next_hop, dst_port;
+ uint32_t next_hop;
+ uint8_t dst_port;
rxq = &qconf->rx_queue_list[queue];
}
/* Find destination port */
- if (rte_lpm6_lookup(rxq->lpm6, ip_hdr->dst_addr, &next_hop) == 0 &&
+ if (rte_lpm6_lookup(rxq->lpm6, ip_hdr->dst_addr,
+ &next_hop) == 0 &&
(enabled_port_mask & 1 << next_hop) != 0) {
dst_port = next_hop;
}
argv[optind-1] = prgname;
ret = optind-1;
- optind = 0; /* reset getopt lib */
+ optind = 1; /* reset getopt lib */
return ret;
}
continue;
}
/* clear all_ports_up flag if any link down */
- if (link.link_status == 0) {
+ if (link.link_status == ETH_LINK_DOWN) {
all_ports_up = 0;
break;
}
nb_mbuf = RTE_MAX(max_flow_num, 2UL * MAX_PKT_BURST) * MAX_FRAG_NUM;
nb_mbuf *= (port_conf.rxmode.max_rx_pkt_len + BUF_SIZE - 1) / BUF_SIZE;
nb_mbuf *= 2; /* ipv4 and ipv6 */
- nb_mbuf += RTE_TEST_RX_DESC_DEFAULT + RTE_TEST_TX_DESC_DEFAULT;
+ nb_mbuf += nb_rxd + nb_txd;
nb_mbuf = RTE_MAX(nb_mbuf, (uint32_t)NB_MBUF);
char buf[PATH_MAX];
struct rte_lpm *lpm;
struct rte_lpm6 *lpm6;
+ struct rte_lpm_config lpm_config;
int socket;
unsigned lcore_id;
RTE_LOG(INFO, IP_RSMBL, "Creating LPM table on socket %i\n", socket);
snprintf(buf, sizeof(buf), "IP_RSMBL_LPM_%i", socket);
- lpm = rte_lpm_create(buf, socket, LPM_MAX_RULES, 0);
+ lpm_config.max_rules = LPM_MAX_RULES;
+ lpm_config.number_tbl8s = 256;
+ lpm_config.flags = 0;
+
+ lpm = rte_lpm_create(buf, socket, &lpm_config);
if (lpm == NULL) {
RTE_LOG(ERR, IP_RSMBL, "Cannot create LPM table\n");
return -1;
RTE_LOG(INFO, IP_RSMBL, "Creating LPM6 table on socket %i\n", socket);
snprintf(buf, sizeof(buf), "IP_RSMBL_LPM_%i", socket);
- lpm6 = rte_lpm6_create("IP_RSMBL_LPM6", socket, &lpm6_config);
+ lpm6 = rte_lpm6_create(buf, socket, &lpm6_config);
if (lpm6 == NULL) {
RTE_LOG(ERR, IP_RSMBL, "Cannot create LPM table\n");
return -1;
rte_exit(EXIT_FAILURE, "Invalid IP reassembly parameters\n");
nb_ports = rte_eth_dev_count();
- if (nb_ports > RTE_MAX_ETHPORTS)
- nb_ports = RTE_MAX_ETHPORTS;
- else if (nb_ports == 0)
+ if (nb_ports == 0)
rte_exit(EXIT_FAILURE, "No ports found!\n");
nb_lcores = rte_lcore_count();
qconf = &lcore_queue_conf[rx_lcore_id];
+ /* limit the frame size to the maximum supported by NIC */
+ rte_eth_dev_info_get(portid, &dev_info);
+ port_conf.rxmode.max_rx_pkt_len = RTE_MIN(
+ dev_info.max_rx_pktlen, port_conf.rxmode.max_rx_pkt_len);
+
/* get the lcore_id for this port */
while (rte_lcore_is_enabled(rx_lcore_id) == 0 ||
qconf->n_rx_queue == (unsigned)rx_queue_per_lcore) {
rxq->portid = portid;
rxq->lpm = socket_lpm[socket];
rxq->lpm6 = socket_lpm6[socket];
+
+ ret = rte_eth_dev_adjust_nb_rx_tx_desc(portid, &nb_rxd,
+ &nb_txd);
+ if (ret < 0)
+ rte_exit(EXIT_FAILURE,
+ "Cannot adjust number of descriptors: err=%d, port=%d\n",
+ ret, portid);
+
if (setup_queue_tbl(rxq, rx_lcore_id, queueid) < 0)
rte_exit(EXIT_FAILURE, "Failed to set up queue table\n");
qconf->n_rx_queue++;
printf("txq=%u,%d,%d ", lcore_id, queueid, socket);
fflush(stdout);
- rte_eth_dev_info_get(portid, &dev_info);
txconf = &dev_info.default_txconf;
txconf->txq_flags = 0;