#define BURST_SIZE 32
static const struct rte_eth_conf port_conf_default = {
- .rxmode = { .max_rx_pkt_len = ETHER_MAX_LEN }
+ .rxmode = { .max_rx_pkt_len = RTE_ETHER_MAX_LEN }
};
/* l2fwd-cat.c: CAT enabled, basic DPDK skeleton forwarding example. */
return retval;
/* Display the port MAC address. */
- struct ether_addr addr;
- rte_eth_macaddr_get(port, &addr);
+ struct rte_ether_addr addr;
+ retval = rte_eth_macaddr_get(port, &addr);
+ if (retval < 0)
+ return retval;
+
printf("Port %u MAC: %02" PRIx8 " %02" PRIx8 " %02" PRIx8
" %02" PRIx8 " %02" PRIx8 " %02" PRIx8 "\n",
port,
addr.addr_bytes[4], addr.addr_bytes[5]);
/* Enable RX in promiscuous mode for the Ethernet device. */
- rte_eth_promiscuous_enable(port);
+ retval = rte_eth_promiscuous_enable(port);
+ if (retval != 0)
+ return retval;
return 0;
}
* The lcore main. This is the main thread that does the work, reading from
* an input port and writing to an output port.
*/
-static __attribute__((noreturn)) void
+static __rte_noreturn void
lcore_main(void)
{
uint16_t port;
argv += ret;
/* Check that there is an even number of ports to send/receive on. */
- nb_ports = rte_eth_dev_count();
+ nb_ports = rte_eth_dev_count_avail();
if (nb_ports < 2 || (nb_ports & 1))
rte_exit(EXIT_FAILURE, "Error: number of ports must be even\n");