#include <rte_memcpy.h>
#include <rte_memzone.h>
#include <rte_eal.h>
-#include <rte_per_lcore.h>
#include <rte_launch.h>
#include <rte_atomic.h>
#include <rte_cycles.h>
struct lcore_conf lcore_conf[RTE_MAX_LCORE];
struct lcore_params {
- uint8_t port_id;
+ uint16_t port_id;
uint8_t queue_id;
uint8_t lcore_id;
} __rte_cache_aligned;
.hw_ip_checksum = 1, /**< IP checksum offload enabled */
.hw_vlan_filter = 0, /**< VLAN filtering disabled */
.jumbo_frame = 0, /**< Jumbo Frame Support disabled */
- .hw_strip_crc = 0, /**< CRC stripped by hardware */
+ .hw_strip_crc = 1, /**< CRC stripped by hardware */
},
.rx_adv_conf = {
.rss_conf = {
static int
check_port_config(const unsigned nb_ports)
{
- unsigned portid;
+ uint16_t portid;
uint16_t i;
for (i = 0; i < nb_lcore_params; ++i) {
}
static uint8_t
-get_port_n_rx_queues(const uint8_t port)
+get_port_n_rx_queues(const uint16_t port)
{
int queue = -1;
uint16_t i;
static void
parse_eth_dest(const char *optarg)
{
- uint8_t portid;
+ uint16_t portid;
char *port_end;
uint8_t c, *dest, peer_addr[6];
* value of 8192
*/
#define NB_MBUF RTE_MAX( \
- (nb_ports*nb_rx_queue*RTE_TEST_RX_DESC_DEFAULT + \
- nb_ports*nb_lcores*MAX_PKT_BURST + \
- nb_ports*n_tx_queue*RTE_TEST_TX_DESC_DEFAULT + \
- nb_lcores*MEMPOOL_CACHE_SIZE), \
+ (nb_ports*nb_rx_queue*nb_rxd + \
+ nb_ports*nb_lcores*MAX_PKT_BURST + \
+ nb_ports*n_tx_queue*nb_txd + \
+ nb_lcores*MEMPOOL_CACHE_SIZE), \
(unsigned)8192)
/* Parse the argument given in the command line of the application */
argv[optind-1] = prgname;
ret = optind-1;
- optind = 0; /* reset getopt lib */
+ optind = 1; /* reset getopt lib */
return ret;
}
/* Check the link status of all ports in up to 9s, and print them finally */
static void
-check_all_ports_link_status(uint8_t port_num, uint32_t port_mask)
+check_all_ports_link_status(uint16_t port_num, uint32_t port_mask)
{
#define CHECK_INTERVAL 100 /* 100ms */
#define MAX_CHECK_TIME 90 /* 9s (90 * 100ms) in total */
- uint8_t portid, count, all_ports_up, print_flag = 0;
+ uint16_t portid;
+ uint8_t count, all_ports_up, print_flag = 0;
struct rte_eth_link link;
printf("\nChecking link status");
/* print link status if flag set */
if (print_flag == 1) {
if (link.link_status)
- printf("Port %d Link Up - speed %u "
- "Mbps - %s\n", (uint8_t)portid,
- (unsigned)link.link_speed,
+ printf(
+ "Port%d Link Up. Speed %u Mbps -%s\n",
+ portid, link.link_speed,
(link.link_duplex == ETH_LINK_FULL_DUPLEX) ?
("full-duplex") : ("half-duplex\n"));
else
- printf("Port %d Link Down\n",
- (uint8_t)portid);
+ printf("Port %d Link Down\n", portid);
continue;
}
/* clear all_ports_up flag if any link down */
}
static int
-prepare_ptype_parser(uint8_t portid, uint16_t queueid)
+prepare_ptype_parser(uint16_t portid, uint16_t queueid)
{
if (parse_ptype) {
printf("Port %d: softly parse packet type info\n", portid);
struct rte_eth_txconf *txconf;
int ret;
unsigned nb_ports;
- uint16_t queueid;
+ uint16_t queueid, portid;
unsigned lcore_id;
uint32_t n_tx_queue, nb_lcores;
- uint8_t portid, nb_rx_queue, queue, socketid;
+ uint8_t nb_rx_queue, queue, socketid;
/* init EAL */
ret = rte_eal_init(argc, argv);
"Cannot configure device: err=%d, port=%d\n",
ret, portid);
+ ret = rte_eth_dev_adjust_nb_rx_tx_desc(portid, &nb_rxd,
+ &nb_txd);
+ if (ret < 0)
+ rte_exit(EXIT_FAILURE,
+ "Cannot adjust number of descriptors: err=%d, "
+ "port=%d\n", ret, portid);
+
rte_eth_macaddr_get(portid, &ports_eth_addr[portid]);
print_ethaddr(" Address:", &ports_eth_addr[portid]);
printf(", ");
}
- check_all_ports_link_status((uint8_t)nb_ports, enabled_port_mask);
+ check_all_ports_link_status(nb_ports, enabled_port_mask);
ret = 0;
/* launch per-lcore init on every lcore */