#include <rte_memcpy.h>
#include <rte_memzone.h>
#include <rte_eal.h>
-#include <rte_per_lcore.h>
#include <rte_launch.h>
#include <rte_atomic.h>
#include <rte_cycles.h>
#include <rte_debug.h>
#include <rte_ether.h>
#include <rte_ethdev.h>
-#include <rte_ring.h>
#include <rte_mempool.h>
#include <rte_mbuf.h>
#include <rte_ip.h>
#include <rte_string_fns.h>
#include <rte_acl.h>
+#if RTE_LOG_LEVEL >= RTE_LOG_DEBUG
+#define L3FWDACL_DEBUG
+#endif
#define DO_RFC_1812_CHECKS
#define RTE_LOGTYPE_L3FWD RTE_LOGTYPE_USER1
*/
#define NB_MBUF RTE_MAX(\
- (nb_ports * nb_rx_queue*RTE_TEST_RX_DESC_DEFAULT + \
- nb_ports * nb_lcores * MAX_PKT_BURST + \
- nb_ports * n_tx_queue * RTE_TEST_TX_DESC_DEFAULT + \
- nb_lcores * MEMPOOL_CACHE_SIZE), \
+ (nb_ports * nb_rx_queue * nb_rxd + \
+ nb_ports * nb_lcores * MAX_PKT_BURST + \
+ nb_ports * n_tx_queue * nb_txd + \
+ nb_lcores * MEMPOOL_CACHE_SIZE), \
(unsigned)8192)
#define MAX_PKT_BURST 32
.hw_ip_checksum = 1, /**< IP checksum offload enabled */
.hw_vlan_filter = 0, /**< VLAN filtering disabled */
.jumbo_frame = 0, /**< Jumbo Frame Support disabled */
- .hw_strip_crc = 0, /**< CRC stripped by hardware */
+ .hw_strip_crc = 1, /**< CRC stripped by hardware */
},
.rx_adv_conf = {
.rss_conf = {
argv[optind-1] = prgname;
ret = optind-1;
- optind = 0; /* reset getopt lib */
+ optind = 1; /* reset getopt lib */
return ret;
}
continue;
}
/* clear all_ports_up flag if any link down */
- if (link.link_status == 0) {
+ if (link.link_status == ETH_LINK_DOWN) {
all_ports_up = 0;
break;
}
unsigned lcore_id;
uint32_t n_tx_queue, nb_lcores;
uint8_t portid, nb_rx_queue, queue, socketid;
- uint8_t nb_tx_port;
/* init EAL */
ret = rte_eal_init(argc, argv);
rte_exit(EXIT_FAILURE, "init_lcore_rx_queues failed\n");
nb_ports = rte_eth_dev_count();
- if (nb_ports > RTE_MAX_ETHPORTS)
- nb_ports = RTE_MAX_ETHPORTS;
if (check_port_config(nb_ports) < 0)
rte_exit(EXIT_FAILURE, "check_port_config failed\n");
rte_exit(EXIT_FAILURE, "app_acl_init failed\n");
nb_lcores = rte_lcore_count();
- nb_tx_port = 0;
/* initialize all ports */
for (portid = 0; portid < nb_ports; portid++) {
"Cannot configure device: err=%d, port=%d\n",
ret, portid);
+ ret = rte_eth_dev_adjust_nb_rx_tx_desc(portid, &nb_rxd,
+ &nb_txd);
+ if (ret < 0)
+ rte_exit(EXIT_FAILURE,
+ "rte_eth_dev_adjust_nb_rx_tx_desc: err=%d, port=%d\n",
+ ret, portid);
+
rte_eth_macaddr_get(portid, &ports_eth_addr[portid]);
print_ethaddr(" Address:", &ports_eth_addr[portid]);
printf(", ");
qconf->tx_queue_id[portid] = queueid;
queueid++;
- qconf->n_tx_port = nb_tx_port;
qconf->tx_port_id[qconf->n_tx_port] = portid;
+ qconf->n_tx_port++;
}
printf("\n");
-
- nb_tx_port++;
}
for (lcore_id = 0; lcore_id < RTE_MAX_LCORE; lcore_id++) {