#include <rte_memcpy.h>
#include <rte_memzone.h>
#include <rte_eal.h>
-#include <rte_per_lcore.h>
#include <rte_launch.h>
#include <rte_atomic.h>
#include <rte_spinlock.h>
#include <rte_debug.h>
#include <rte_ether.h>
#include <rte_ethdev.h>
-#include <rte_ring.h>
#include <rte_mempool.h>
#include <rte_mbuf.h>
#include <rte_ip.h>
* RTE_MAX is used to ensure that NB_MBUF never goes below a minimum value of 8192
*/
-#define NB_MBUF RTE_MAX ( \
- (nb_ports*nb_rx_queue*RTE_TEST_RX_DESC_DEFAULT + \
- nb_ports*nb_lcores*MAX_PKT_BURST + \
- nb_ports*n_tx_queue*RTE_TEST_TX_DESC_DEFAULT + \
- nb_lcores*MEMPOOL_CACHE_SIZE), \
+#define NB_MBUF RTE_MAX ( \
+ (nb_ports*nb_rx_queue*nb_rxd + \
+ nb_ports*nb_lcores*MAX_PKT_BURST + \
+ nb_ports*n_tx_queue*nb_txd + \
+ nb_lcores*MEMPOOL_CACHE_SIZE), \
(unsigned)8192)
/*
.hw_ip_checksum = 1, /**< IP checksum offload enabled */
.hw_vlan_filter = 0, /**< VLAN filtering disabled */
.jumbo_frame = 0, /**< Jumbo Frame Support disabled */
- .hw_strip_crc = 0, /**< CRC stripped by hardware */
+ .hw_strip_crc = 1, /**< CRC stripped by hardware */
},
.rx_adv_conf = {
.rss_conf = {
#if (APP_LOOKUP_METHOD == APP_LOOKUP_EXACT_MATCH)
-#ifdef RTE_MACHINE_CPUFLAG_SSE4_2
+#ifdef RTE_ARCH_X86
#include <rte_hash_crc.h>
#define DEFAULT_HASH_FUNC rte_hash_crc
#else
struct rte_hash_parameters l3fwd_hash_params = {
.name = "l3fwd_hash_0",
.entries = L3FWD_HASH_ENTRIES,
- .bucket_entries = 4,
.key_len = sizeof(struct ipv4_5tuple),
.hash_func = DEFAULT_HASH_FUNC,
.hash_func_init_val = 0,
static inline uint8_t
get_dst_port(struct ipv4_hdr *ipv4_hdr, uint8_t portid, lookup_struct_t * l3fwd_lookup_struct)
{
- uint8_t next_hop;
+ uint32_t next_hop;
return (uint8_t) ((rte_lpm_lookup(l3fwd_lookup_struct,
rte_be_to_cpu_32(ipv4_hdr->dst_addr), &next_hop) == 0)?
eth_hdr = rte_pktmbuf_mtod(m, struct ether_hdr *);
- ipv4_hdr = (struct ipv4_hdr *)(rte_pktmbuf_mtod(m, unsigned char *) +
- sizeof(struct ether_hdr));
+ ipv4_hdr = rte_pktmbuf_mtod_offset(m, struct ipv4_hdr *,
+ sizeof(struct ether_hdr));
#ifdef DO_RFC_1812_CHECKS
/* Check to make sure the packet is valid (RFC1812) */
argv[optind-1] = prgname;
ret = optind-1;
- optind = 0; /* reset getopt lib */
+ optind = 1; /* reset getopt lib */
return ret;
}
int ret;
char s[64];
+ struct rte_lpm_config lpm_ipv4_config;
+
+ lpm_ipv4_config.max_rules = L3FWD_LPM_MAX_RULES;
+ lpm_ipv4_config.number_tbl8s = 256;
+ lpm_ipv4_config.flags = 0;
+
/* create the LPM table */
snprintf(s, sizeof(s), "L3FWD_LPM_%d", socketid);
- l3fwd_lookup_struct[socketid] = rte_lpm_create(s, socketid,
- L3FWD_LPM_MAX_RULES, 0);
+ l3fwd_lookup_struct[socketid] =
+ rte_lpm_create(s, socketid, &lpm_ipv4_config);
if (l3fwd_lookup_struct[socketid] == NULL)
rte_exit(EXIT_FAILURE, "Unable to create the l3fwd LPM table"
" on socket %d\n", socketid);
rte_exit(EXIT_FAILURE, "init_lcore_rx_queues failed\n");
nb_ports = rte_eth_dev_count();
- if (nb_ports > RTE_MAX_ETHPORTS)
- nb_ports = RTE_MAX_ETHPORTS;
if (check_port_config(nb_ports) < 0)
rte_exit(EXIT_FAILURE, "check_port_config failed\n");
rte_exit(EXIT_FAILURE, "Cannot configure device: err=%d, port=%d\n",
ret, portid);
+ ret = rte_eth_dev_adjust_nb_rx_tx_desc(portid, &nb_rxd,
+ &nb_txd);
+ if (ret < 0)
+ rte_exit(EXIT_FAILURE,
+ "Cannot adjust number of descriptors: err=%d, port=%d\n",
+ ret, portid);
+
rte_eth_macaddr_get(portid, &ports_eth_addr[portid]);
print_ethaddr(" Address:", &ports_eth_addr[portid]);
printf(", ");