#include <stdint.h>
#include <inttypes.h>
#include <sys/types.h>
-#include <string.h>
#include <sys/queue.h>
#include <netinet/in.h>
#include <setjmp.h>
#include <rte_memcpy.h>
#include <rte_memzone.h>
#include <rte_eal.h>
-#include <rte_per_lcore.h>
#include <rte_launch.h>
#include <rte_atomic.h>
#include <rte_cycles.h>
{
struct rte_eth_link link;
uint64_t total_packets_dropped, total_packets_tx, total_packets_rx;
- unsigned portid;
+ uint16_t portid;
total_packets_dropped = 0;
total_packets_tx = 0;
continue;
memset(&link, 0, sizeof(link));
- rte_eth_link_get_nowait((uint8_t)portid, &link);
+ rte_eth_link_get_nowait(portid, &link);
printf("\nStatistics for port %u ------------------------------"
"\nLink status: %25s"
"\nLink speed: %26u"
* Pointer to(address of) the parameters.
*
* @return
- * void.
+ * int.
*/
-static void
-lsi_event_callback(uint8_t port_id, enum rte_eth_event_type type, void *param)
+static int
+lsi_event_callback(uint16_t port_id, enum rte_eth_event_type type, void *param,
+ void *ret_param)
{
struct rte_eth_link link;
RTE_SET_USED(param);
+ RTE_SET_USED(ret_param);
printf("\n\nIn registered callback...\n");
printf("Event type: %s\n", type == RTE_ETH_EVENT_INTR_LSC ? "LSC interrupt" : "unknown event");
("full-duplex") : ("half-duplex"));
} else
printf("Port %d Link Down\n\n", port_id);
+
+ return 0;
}
/* Check the link status of all ports in up to 9s, and print them finally */
{
#define CHECK_INTERVAL 100 /* 100ms */
#define MAX_CHECK_TIME 90 /* 9s (90 * 100ms) in total */
- uint8_t portid, count, all_ports_up, print_flag = 0;
+ uint8_t count, all_ports_up, print_flag = 0;
+ uint16_t portid;
struct rte_eth_link link;
printf("\nChecking link status");
rte_exit(EXIT_FAILURE, "Cannot configure device: err=%d, port=%u\n",
ret, (unsigned) portid);
+ ret = rte_eth_dev_adjust_nb_rx_tx_desc(portid, &nb_rxd,
+ &nb_txd);
+ if (ret < 0)
+ rte_exit(EXIT_FAILURE,
+ "rte_eth_dev_adjust_nb_rx_tx_desc: err=%d, port=%u\n",
+ ret, (unsigned) portid);
+
/* register lsi interrupt callback, need to be after
* rte_eth_dev_configure(). if (intr_conf.lsc == 0), no
* lsc interrupt will be present, and below callback to