/*
* Configurable number of RX/TX ring descriptors
*/
-#define RTE_TEST_RX_DESC_DEFAULT 128
-#define RTE_TEST_TX_DESC_DEFAULT 128
+#define RTE_TEST_RX_DESC_DEFAULT 1024
+#define RTE_TEST_TX_DESC_DEFAULT 1024
static uint16_t nb_rxd = RTE_TEST_RX_DESC_DEFAULT;
static uint16_t nb_txd = RTE_TEST_TX_DESC_DEFAULT;
.mq_mode = ETH_MQ_RX_RSS,
.max_rx_pkt_len = ETHER_MAX_LEN,
.split_hdr_size = 0,
- .header_split = 0, /**< Header Split disabled */
- .hw_ip_checksum = 1, /**< IP checksum offload enabled */
- .hw_vlan_filter = 0, /**< VLAN filtering disabled */
- .jumbo_frame = 0, /**< Jumbo Frame Support disabled */
- .hw_strip_crc = 1, /**< CRC stripped by hardware */
+ .ignore_offload_bitfield = 1,
+ .offloads = (DEV_RX_OFFLOAD_CHECKSUM |
+ DEV_RX_OFFLOAD_CRC_STRIP),
},
.rx_adv_conf = {
.rss_conf = {
}
static int
-check_port_config(const unsigned nb_ports)
+check_port_config(void)
{
unsigned portid;
uint16_t i;
printf("port %u is not enabled in port mask\n", portid);
return -1;
}
- if (portid >= nb_ports) {
+ if (!rte_eth_dev_is_valid_port(portid)) {
printf("port %u is not present on the board\n", portid);
return -1;
}
0};
printf("jumbo frame is enabled - disabling simple TX path\n");
- port_conf.rxmode.jumbo_frame = 1;
+ port_conf.rxmode.offloads |=
+ DEV_RX_OFFLOAD_JUMBO_FRAME;
+ port_conf.txmode.offloads |=
+ DEV_TX_OFFLOAD_MULTI_SEGS;
/* if no max-pkt-len set, use the default value ETHER_MAX_LEN */
if (0 == getopt_long(argc, argvopt, "", &lenopts,
/* Check the link status of all ports in up to 9s, and print them finally */
static void
-check_all_ports_link_status(uint16_t port_num, uint32_t port_mask)
+check_all_ports_link_status(uint32_t port_mask)
{
#define CHECK_INTERVAL 100 /* 100ms */
#define MAX_CHECK_TIME 90 /* 9s (90 * 100ms) in total */
fflush(stdout);
for (count = 0; count <= MAX_CHECK_TIME; count++) {
all_ports_up = 1;
- for (portid = 0; portid < port_num; portid++) {
+ RTE_ETH_FOREACH_DEV(portid) {
if ((port_mask & (1 << portid)) == 0)
continue;
memset(&link, 0, sizeof(link));
nb_ports = rte_eth_dev_count();
- if (check_port_config(nb_ports) < 0)
+ if (check_port_config() < 0)
rte_exit(EXIT_FAILURE, "check_port_config failed\n");
nb_lcores = rte_lcore_count();
/* initialize all ports */
- for (portid = 0; portid < nb_ports; portid++) {
+ RTE_ETH_FOREACH_DEV(portid) {
+ struct rte_eth_conf local_port_conf = port_conf;
+
/* skip ports that are not enabled */
if ((enabled_port_mask & (1 << portid)) == 0) {
printf("\nSkipping disabled port %d\n", portid);
n_tx_queue = MAX_TX_QUEUE_PER_PORT;
printf("Creating queues: nb_rxq=%d nb_txq=%u... ",
nb_rx_queue, (unsigned)n_tx_queue);
+ rte_eth_dev_info_get(portid, &dev_info);
+ if (dev_info.tx_offload_capa & DEV_TX_OFFLOAD_MBUF_FAST_FREE)
+ local_port_conf.txmode.offloads |=
+ DEV_TX_OFFLOAD_MBUF_FAST_FREE;
ret = rte_eth_dev_configure(portid, nb_rx_queue,
- (uint16_t)n_tx_queue, &port_conf);
+ (uint16_t)n_tx_queue, &local_port_conf);
if (ret < 0)
rte_exit(EXIT_FAILURE, "Cannot configure device: err=%d, port=%d\n",
ret, portid);
printf("txq=%u,%d,%d ", lcore_id, queueid, socketid);
fflush(stdout);
- rte_eth_dev_info_get(portid, &dev_info);
txconf = &dev_info.default_txconf;
- if (port_conf.rxmode.jumbo_frame)
- txconf->txq_flags = 0;
+ txconf->txq_flags = ETH_TXQ_FLAGS_IGNORE;
+ txconf->offloads = local_port_conf.txmode.offloads;
ret = rte_eth_tx_queue_setup(portid, queueid, nb_txd,
socketid, txconf);
if (ret < 0)
/* init RX queues */
for (queue = 0; queue < rx_thread[i].n_rx_queue; ++queue) {
+ struct rte_eth_dev *dev;
+ struct rte_eth_conf *conf;
+ struct rte_eth_rxconf rxq_conf;
+
portid = rx_thread[i].rx_queue_list[queue].port_id;
queueid = rx_thread[i].rx_queue_list[queue].queue_id;
+ dev = &rte_eth_devices[portid];
+ conf = &dev->data->dev_conf;
if (numa_on)
socketid = (uint8_t)rte_lcore_to_socket_id(lcore_id);
printf("rxq=%d,%d,%d ", portid, queueid, socketid);
fflush(stdout);
+ rte_eth_dev_info_get(portid, &dev_info);
+ rxq_conf = dev_info.default_rxconf;
+ rxq_conf.offloads = conf->rxmode.offloads;
ret = rte_eth_rx_queue_setup(portid, queueid, nb_rxd,
socketid,
- NULL,
+ &rxq_conf,
pktmbuf_pool[socketid]);
if (ret < 0)
rte_exit(EXIT_FAILURE, "rte_eth_rx_queue_setup: err=%d, "
printf("\n");
/* start ports */
- for (portid = 0; portid < nb_ports; portid++) {
+ RTE_ETH_FOREACH_DEV(portid) {
if ((enabled_port_mask & (1 << portid)) == 0)
continue;
}
}
- check_all_ports_link_status((uint8_t)nb_ports, enabled_port_mask);
+ check_all_ports_link_status(enabled_port_mask);
if (lthreads_on) {
printf("Starting L-Threading Model\n");