net/mlx5: implement vectorized MPRQ burst

[dpdk.git] / lib / librte_ethdev / rte_ethdev.h

diff --git a/lib/librte_ethdev/rte_ethdev.h b/lib/librte_ethdev/rte_ethdev.h
index e341a08..f689550 100644 (file)
--- a/lib/librte_ethdev/rte_ethdev.h
+++ b/lib/librte_ethdev/rte_ethdev.h
@@ -1344,6 +1344,11 @@ struct rte_eth_conf {
 #define DEV_RX_OFFLOAD_VLAN_EXTEND     0x00000400
 #define DEV_RX_OFFLOAD_JUMBO_FRAME     0x00000800
 #define DEV_RX_OFFLOAD_SCATTER         0x00002000
+/**
+ * Timestamp is set by the driver in RTE_MBUF_DYNFIELD_TIMESTAMP_NAME
+ * and RTE_MBUF_DYNFLAG_RX_TIMESTAMP_NAME is set in ol_flags.
+ * The mbuf field and flag are registered when the offload is configured.
+ */
 #define DEV_RX_OFFLOAD_TIMESTAMP       0x00004000
 #define DEV_RX_OFFLOAD_SECURITY         0x00008000
 #define DEV_RX_OFFLOAD_KEEP_CRC                0x00010000
@@ -1408,8 +1413,11 @@ struct rte_eth_conf {
 #define DEV_TX_OFFLOAD_IP_TNL_TSO       0x00080000
 /** Device supports outer UDP checksum */
 #define DEV_TX_OFFLOAD_OUTER_UDP_CKSUM  0x00100000
-
-/** Device supports send on timestamp */
+/**
+ * Device sends on time read from RTE_MBUF_DYNFIELD_TIMESTAMP_NAME
+ * if RTE_MBUF_DYNFLAG_TX_TIMESTAMP_NAME is set in ol_flags.
+ * The mbuf field and flag are registered when the offload is configured.
+ */
 #define DEV_TX_OFFLOAD_SEND_ON_TIMESTAMP 0x00200000
 
 
@@ -4646,7 +4654,7 @@ int rte_eth_timesync_write_time(uint16_t port_id, const struct timespec *time);
  * rte_eth_read_clock(port, base_clock);
  *
  * Then, convert the raw mbuf timestamp with:
- * base_time_sec + (double)(mbuf->timestamp - base_clock) / freq;
+ * base_time_sec + (double)(*timestamp_dynfield(mbuf) - base_clock) / freq;
  *
  * This simple example will not provide a very good accuracy. One must
  * at least measure multiple times the frequency and do a regression.