#include <stdint.h>
+/* Use this macro to check if LRO API is supported */
+#define RTE_ETHDEV_HAS_LRO_SUPPORT
+
#include <rte_log.h>
#include <rte_interrupts.h>
#include <rte_pci.h>
enum rte_eth_rx_mq_mode mq_mode;
uint32_t max_rx_pkt_len; /**< Only used if jumbo_frame enabled. */
uint16_t split_hdr_size; /**< hdr buf size (header_split enabled).*/
- uint8_t header_split : 1, /**< Header Split enable. */
+ uint16_t header_split : 1, /**< Header Split enable. */
hw_ip_checksum : 1, /**< IP/UDP/TCP checksum offload enable. */
hw_vlan_filter : 1, /**< VLAN filter enable. */
hw_vlan_strip : 1, /**< VLAN strip enable. */
hw_vlan_extend : 1, /**< Extended VLAN enable. */
jumbo_frame : 1, /**< Jumbo Frame Receipt enable. */
hw_strip_crc : 1, /**< Enable CRC stripping by hardware. */
- enable_scatter : 1; /**< Enable scatter packets rx handler */
+ enable_scatter : 1, /**< Enable scatter packets rx handler */
+ enable_lro : 1; /**< Enable LRO */
};
/**
uint8_t port_id; /**< Device [external] port identifier. */
uint8_t promiscuous : 1, /**< RX promiscuous mode ON(1) / OFF(0). */
scattered_rx : 1, /**< RX of scattered packets is ON(1) / OFF(0) */
+ lro : 1, /**< RX LRO is ON(1) / OFF(0) */
all_multicast : 1, /**< RX all multicast mode ON(1) / OFF(0). */
dev_started : 1; /**< Device state: STARTED(1) / STOPPED(0). */
};