-/*-
- * BSD LICENSE
- *
- * Copyright(c) 2010-2017 Intel Corporation. All rights reserved.
- * All rights reserved.
- *
- * Redistribution and use in source and binary forms, with or without
- * modification, are permitted provided that the following conditions
- * are met:
- *
- * * Redistributions of source code must retain the above copyright
- * notice, this list of conditions and the following disclaimer.
- * * Redistributions in binary form must reproduce the above copyright
- * notice, this list of conditions and the following disclaimer in
- * the documentation and/or other materials provided with the
- * distribution.
- * * Neither the name of Intel Corporation nor the names of its
- * contributors may be used to endorse or promote products derived
- * from this software without specific prior written permission.
- *
- * THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT HOLDERS AND CONTRIBUTORS
- * "AS IS" AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT
- * LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR
- * A PARTICULAR PURPOSE ARE DISCLAIMED. IN NO EVENT SHALL THE COPYRIGHT
- * OWNER OR CONTRIBUTORS BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL,
- * SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT
- * LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS OF USE,
- * DATA, OR PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED AND ON ANY
- * THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT LIABILITY, OR TORT
- * (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY OUT OF THE USE
- * OF THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE.
+/* SPDX-License-Identifier: BSD-3-Clause
+ * Copyright(c) 2010-2017 Intel Corporation
*/
#ifndef _RTE_ETHDEV_H_
#include <rte_dev.h>
#include <rte_devargs.h>
#include <rte_errno.h>
+#include <rte_common.h>
+
#include "rte_ether.h"
#include "rte_eth_ctrl.h"
#include "rte_dev_info.h"
enable_scatter : 1, /**< Enable scatter packets rx handler */
enable_lro : 1, /**< Enable LRO */
hw_timestamp : 1, /**< Enable HW timestamp */
+ security : 1, /**< Enable rte_security offloads */
/**
* When set the offload bitfield should be ignored.
* Instead per-port Rx offloads should be set on offloads
#define DEV_RX_OFFLOAD_CRC_STRIP 0x00001000
#define DEV_RX_OFFLOAD_SCATTER 0x00002000
#define DEV_RX_OFFLOAD_TIMESTAMP 0x00004000
+#define DEV_RX_OFFLOAD_SECURITY 0x00008000
#define DEV_RX_OFFLOAD_CHECKSUM (DEV_RX_OFFLOAD_IPV4_CKSUM | \
DEV_RX_OFFLOAD_UDP_CKSUM | \
DEV_RX_OFFLOAD_TCP_CKSUM)
* When set application must guarantee that per-queue all mbufs comes from
* the same mempool and has refcnt = 1.
*/
+#define DEV_TX_OFFLOAD_SECURITY 0x00020000
struct rte_pci_device;
/**
* Ethernet device TX queue information structure.
- * Used to retieve information about configured queue.
+ * Used to retrieve information about configured queue.
*/
struct rte_eth_txq_info {
struct rte_eth_txconf conf; /**< queue config parameters. */
} \
} while (0)
-#define RTE_ETH_DEV_TO_PCI(eth_dev) RTE_DEV_TO_PCI((eth_dev)->device)
-
/**
* l2 tunnel configuration.
*/
enum rte_vlan_type type, uint16_t tpid);
/**< @internal set the outer/inner VLAN-TPID by an Ethernet device. */
-typedef void (*vlan_offload_set_t)(struct rte_eth_dev *dev, int mask);
+typedef int (*vlan_offload_set_t)(struct rte_eth_dev *dev, int mask);
/**< @internal set VLAN offload function by an Ethernet device. */
typedef int (*vlan_pvid_set_t)(struct rte_eth_dev *dev,
*/
struct rte_eth_rxtx_callback *pre_tx_burst_cbs[RTE_MAX_QUEUES_PER_PORT];
enum rte_eth_dev_state state; /**< Flag indicating the port state */
+ void *security_ctx; /**< Context for security ops */
} __rte_cache_aligned;
+void *
+rte_eth_dev_get_sec_ctx(uint8_t port_id);
+
struct rte_eth_dev_sriov {
uint8_t active; /**< SRIOV is active with 16, 32 or 64 pools */
uint8_t nb_q_per_pool; /**< rx queue number per pool */
/**< VLAN filter configuration. */
};
-/** Device supports hotplug detach */
-#define RTE_ETH_DEV_DETACHABLE 0x0001
/** Device supports link state interrupt */
#define RTE_ETH_DEV_INTR_LSC 0x0002
/** Device is a bonded slave */
*
* @param port_id
* The port identifier of the Ethernet device.
+ *
+ * @return
+ * - (0) if successful.
+ * - (-EINVAL) if port identifier is invalid.
+ * - (-ENOTSUP) if hardware doesn't support this function.
+ * - (-EPERM) if not ran from the primary process.
+ * - (-EIO) if re-initialisation failed.
+ * - (-ENOMEM) if the reset failed due to OOM.
+ * - (-EAGAIN) if the reset temporarily failed and should be retried later.
*/
int rte_eth_dev_reset(uint16_t port_id);