net/qede/base: remove unneeded step in HW init

There is no need to close the OUT_EN NIG registers, so remove that.

Signed-off-by: Rasesh Mody <rasesh.mody@cavium.com>

diff --git a/drivers/net/qede/base/ecore_dev.c b/drivers/net/qede/base/ecore_dev.c
index 907566c..e2d4132 100644 (file)
--- a/drivers/net/qede/base/ecore_dev.c
+++ b/drivers/net/qede/base/ecore_dev.c
@@ -999,18 +999,6 @@ static enum _ecore_status_t ecore_hw_init_common(struct ecore_hwfn *p_hwfn,
 
        ecore_cxt_hw_init_common(p_hwfn);
 
-       /* Close gate from NIG to BRB/Storm; By default they are open, but
-        * we close them to prevent NIG from passing data to reset blocks.
-        * Should have been done in the ENGINE phase, but init-tool lacks
-        * proper port-pretend capabilities.
-        */
-       ecore_wr(p_hwfn, p_ptt, NIG_REG_RX_BRB_OUT_EN, 0);
-       ecore_wr(p_hwfn, p_ptt, NIG_REG_STORM_OUT_EN, 0);
-       ecore_port_pretend(p_hwfn, p_ptt, p_hwfn->port_id ^ 1);
-       ecore_wr(p_hwfn, p_ptt, NIG_REG_RX_BRB_OUT_EN, 0);
-       ecore_wr(p_hwfn, p_ptt, NIG_REG_STORM_OUT_EN, 0);
-       ecore_port_unpretend(p_hwfn, p_ptt);
-
        rc = ecore_init_run(p_hwfn, p_ptt, PHASE_ENGINE, ANY_PHASE_ID, hw_mode);
        if (rc != ECORE_SUCCESS)
                return rc;