struct hns3_cmd_desc desc;
uint32_t compat = 0;
-#if defined(RTE_HNS3_ONLY_1630_FPGA)
- /* If resv reg enabled phy driver of imp is not configured, driver
- * will use temporary phy driver.
- */
- struct rte_pci_device *pci_dev;
- struct rte_eth_dev *eth_dev;
- uint8_t revision;
- int ret;
-
- eth_dev = &rte_eth_devices[hw->data->port_id];
- pci_dev = RTE_ETH_DEV_TO_PCI(eth_dev);
- /* Get PCI revision id */
- ret = rte_pci_read_config(pci_dev, &revision, HNS3_PCI_REVISION_ID_LEN,
- HNS3_PCI_REVISION_ID);
- if (ret != HNS3_PCI_REVISION_ID_LEN) {
- PMD_INIT_LOG(ERR, "failed to read pci revision id, ret = %d",
- ret);
- return -EIO;
- }
- if (revision == PCI_REVISION_ID_HIP09_A) {
- struct hns3_pf *pf = HNS3_DEV_HW_TO_PF(hw);
- if (hns3_dev_get_support(hw, COPPER) == 0 || pf->is_tmp_phy) {
- PMD_INIT_LOG(ERR, "***use temp phy driver in dpdk***");
- pf->is_tmp_phy = true;
- hns3_set_bit(hw->capability,
- HNS3_DEV_SUPPORT_COPPER_B, 1);
- return 0;
- }
-
- PMD_INIT_LOG(ERR, "***use phy driver in imp***");
- }
-#endif
-
hns3_cmd_setup_basic_desc(&desc, HNS3_OPC_FIRMWARE_COMPAT_CFG, false);
req = (struct hns3_firmware_compat_cmd *)desc.data;
{
int ret;
- if (hw->mac.media_type == HNS3_MEDIA_TYPE_COPPER) {
-#if defined(RTE_HNS3_ONLY_1630_FPGA)
- struct hns3_pf *pf = HNS3_DEV_HW_TO_PF(hw);
- if (pf->is_tmp_phy)
- return 0;
-#endif
-
+ if (hw->mac.media_type == HNS3_MEDIA_TYPE_COPPER)
ret = hns3_set_copper_port_link_speed(hw, cfg);
- } else {
+ else
ret = hns3_set_fiber_port_link_speed(hw, cfg);
- }
if (ret) {
hns3_err(hw, "failed to set %s port link speed, ret = %d.",