The jumbo frame uses the 'RTE_ETHER_MAX_LEN' as boundary condition.
If the Ether overhead is larger than 18 when it supports VLAN tag,
that will cause the jumbo flag rx offload is wrong when MTU size is
'RTE_ETHER_MTU'.
This fix will normalize the boundary condition with 'RTE_ETHER_MTU'
and overhead even though current overhead is 18.
Fixes: 59d0ecdbf0e1 ("ethdev: MTU accessors")
Fixes: 95a27b3ba5f5 ("net/ixgbe: enable jumbo frame for VF")
Cc: stable@dpdk.org
Signed-off-by: Steve Yang <stevex.yang@intel.com>
Acked-by: Jeff Guo <jia.guo@intel.com>
        hlreg0 = IXGBE_READ_REG(hw, IXGBE_HLREG0);
 
        /* switch to jumbo mode if needed */
-       if (frame_size > RTE_ETHER_MAX_LEN) {
+       if (frame_size > IXGBE_ETH_MAX_LEN) {
                dev->data->dev_conf.rxmode.offloads |=
                        DEV_RX_OFFLOAD_JUMBO_FRAME;
                hlreg0 |= IXGBE_HLREG0_JUMBOEN;
 
 /* The overhead from MTU to max frame size. */
 #define IXGBE_ETH_OVERHEAD (RTE_ETHER_HDR_LEN + RTE_ETHER_CRC_LEN)
 
+/* The max frame size with default MTU */
+#define IXGBE_ETH_MAX_LEN  (RTE_ETHER_MTU + IXGBE_ETH_OVERHEAD)
+
 /* bit of VXLAN tunnel type | 7 bits of zeros  | 8 bits of zeros*/
 #define IXGBE_FDIR_VXLAN_TUNNEL_TYPE    0x8000
 /* bit of NVGRE tunnel type | 7 bits of zeros  | 8 bits of zeros*/
 
                   IXGBE_MHADD_MFS_MASK) >> IXGBE_MHADD_MFS_SHIFT;
        if (max_frs < new_mtu) {
                hlreg0 = IXGBE_READ_REG(hw, IXGBE_HLREG0);
-               if (new_mtu > RTE_ETHER_MAX_LEN) {
+               if (new_mtu > IXGBE_ETH_MAX_LEN) {
                        dev->data->dev_conf.rxmode.offloads |=
                                DEV_RX_OFFLOAD_JUMBO_FRAME;
                        hlreg0 |= IXGBE_HLREG0_JUMBOEN;