}
/**
- * This is based on ixgbe_get_fdirtcpm_82599(), in ixgbe/ixgbe_82599.c. It no
- * longer does the byte reordering
+ * Reverse the bits in FDIR registers that store 2 x 16 bit masks.
*
- * generate a tcp port from atr_input_masks
- * @input_mask: mask to be bit swapped
+ * @hi_dword: Bits 31:16 mask to be bit swapped.
+ * @lo_dword: Bits 15:0 mask to be bit swapped.
*
- * The source and destination port masks for flow director are bit swapped
- * in that bit 15 effects bit 0, 14 effects 1, 13, 2 etc. In order to
- * generate a correctly swapped value we need to bit swap the mask and that
- * is what is accomplished by this function.
- **/
+ * Flow director uses several registers to store 2 x 16 bit masks with the
+ * bits reversed such as FDIRTCPM, FDIRUDPM and FDIRIP6M. The LS bit of the
+ * mask affects the MS bit/byte of the target. This function reverses the
+ * bits in these masks.
+ * **/
static uint32_t
-get_fdirtcpm_82599(struct rte_fdir_masks *input_mask)
+reverse_fdir_bitmasks(uint16_t hi_dword, uint16_t lo_dword)
{
- u32 mask = input_mask->dst_port_mask;
- mask <<= IXGBE_FDIRTCPM_DPORTM_SHIFT;
- mask |= input_mask->src_port_mask;
+ u32 mask = hi_dword << 16;
+ mask |= lo_dword;
mask = ((mask & 0x55555555) << 1) | ((mask & 0xAAAAAAAA) >> 1);
mask = ((mask & 0x33333333) << 2) | ((mask & 0xCCCCCCCC) >> 2);
mask = ((mask & 0x0F0F0F0F) << 4) | ((mask & 0xF0F0F0F0) >> 4);
fdir_set_input_mask_82599(struct ixgbe_hw *hw,
struct rte_fdir_masks *input_mask)
{
- /* mask VM pool and IPv6 since it is currently not supported */
- u32 fdirm = IXGBE_FDIRM_POOL | IXGBE_FDIRM_DIPv6;
- u32 fdirtcpm;
+ /* mask VM pool since it is currently not supported */
+ u32 fdirm = IXGBE_FDIRM_POOL;
+ u32 fdirtcpm; /* TCP source and destination port masks. */
+ u32 fdiripv6m; /* IPv6 source and destination masks. */
PMD_INIT_FUNC_TRACE();
* are zero, then assume a full mask for that field. Also assume that
* a VLAN of 0 is unspecified, so mask that out as well. L4type
* cannot be masked out in this implementation.
- *
- * This also assumes IPv4 only. IPv6 masking isn't supported at this
- * point in time.
*/
if (input_mask->only_ip_flow) {
/* use the L4 protocol mask for raw IPv4/IPv6 traffic */
}
}
+ if (!input_mask->comp_ipv6_dst)
+ /* mask DIPV6 */
+ fdirm |= IXGBE_FDIRM_DIPv6;
+
if (!input_mask->vlan_id)
/* mask VLAN ID*/
fdirm |= IXGBE_FDIRM_VLANID;
IXGBE_WRITE_REG(hw, IXGBE_FDIRM, fdirm);
/* store the TCP/UDP port masks, bit reversed from port layout */
- fdirtcpm = get_fdirtcpm_82599(input_mask);
+ fdirtcpm = reverse_fdir_bitmasks(input_mask->dst_port_mask,
+ input_mask->src_port_mask);
/* write both the same so that UDP and TCP use the same mask */
IXGBE_WRITE_REG(hw, IXGBE_FDIRTCPM, ~fdirtcpm);
IXGBE_WRITE_REG(hw, IXGBE_FDIRUDPM, ~fdirtcpm);
- /* store source and destination IP masks (big-enian) */
+ if (!input_mask->set_ipv6_mask) {
+ /* Store source and destination IPv4 masks (big-endian) */
IXGBE_WRITE_REG_BE32(hw, IXGBE_FDIRSIP4M,
IXGBE_NTOHL(~input_mask->src_ipv4_mask));
IXGBE_WRITE_REG_BE32(hw, IXGBE_FDIRDIP4M,
IXGBE_NTOHL(~input_mask->dst_ipv4_mask));
+ }
+ else {
+ /* Store source and destination IPv6 masks (bit reversed) */
+ fdiripv6m = reverse_fdir_bitmasks(input_mask->dst_ipv6_mask,
+ input_mask->src_ipv6_mask);
+
+ IXGBE_WRITE_REG(hw, IXGBE_FDIRIP6M, ~fdiripv6m);
+ }
return IXGBE_SUCCESS;
}