ixgbe: fix PF promiscuous mode after VF closed

There's an issue reported. In the scenario DPDK PF + DPDK VF,
if the VF port is closed, PF port cannot receive packets.
I found at that time the promicuous mode is disabled on the PF
port. But it should be enabled.
When VF port is closed, it will send a message to its PF port to
reset it. During this, PF port will also reset its own
promicuous mode. Which promiscuous mode should be set depends on
the parameter stored in the device data. In the function
set_rx_mode, the pointer of device data points to the wrong
address. So, the promiscuous mode is wrong.

Fixes: 00e30184daa0 ("ixgbe: add PF support")

Signed-off-by: Wenzhuo Lu <wenzhuo.lu@intel.com>
Reported-by: Bernard Iremonger <bernard.iremonger@intel.com>
Acked-by: Jingjing Wu <jingjing.wu@intel.com>

diff --git a/drivers/net/ixgbe/ixgbe_pf.c b/drivers/net/ixgbe/ixgbe_pf.c
index b854c72..a540343 100644 (file)
--- a/drivers/net/ixgbe/ixgbe_pf.c
+++ b/drivers/net/ixgbe/ixgbe_pf.c
@@ -312,8 +312,7 @@ int ixgbe_pf_host_configure(struct rte_eth_dev *eth_dev)
 static void
 set_rx_mode(struct rte_eth_dev *dev)
 {
-       struct rte_eth_dev_data *dev_data =
-               (struct rte_eth_dev_data*)dev->data->dev_private;
+       struct rte_eth_dev_data *dev_data = dev->data;
        struct ixgbe_hw *hw = IXGBE_DEV_PRIVATE_TO_HW(dev->data->dev_private);
        u32 fctrl, vmolr = IXGBE_VMOLR_BAM | IXGBE_VMOLR_AUPE;
        uint16_t vfn = dev_num_vf(dev);