net/enic: set L4 checksum flags for IPv6 packets

enic_cq_rx_to_pkt_flags() currently sets checksum good/bad flags only
for IPv4.  The hardware actually validates the TCP/UDP checksum of
IPv6 packets too. Set PKT_RX_L4_CKSUM_{GOOD,BAD} accordingly.

Signed-off-by: Hyong Youb Kim <hyonkim@cisco.com>
Reviewed-by: John Daley <johndale@cisco.com>

diff --git a/drivers/net/enic/enic_rxtx.c b/drivers/net/enic/enic_rxtx.c
index 5b743eb..2fe5a3f 100644 (file)
--- a/drivers/net/enic/enic_rxtx.c
+++ b/drivers/net/enic/enic_rxtx.c
@@ -195,14 +195,14 @@ enic_cq_rx_to_pkt_flags(struct cq_desc *cqd, struct rte_mbuf *mbuf)
        }
 
        /* checksum flags */
-       if (mbuf->packet_type & RTE_PTYPE_L3_IPV4) {
+       if (mbuf->packet_type & (RTE_PTYPE_L3_IPV4 | RTE_PTYPE_L3_IPV6)) {
                if (!enic_cq_rx_desc_csum_not_calc(cqrd)) {
                        uint32_t l4_flags;
                        l4_flags = mbuf->packet_type & RTE_PTYPE_L4_MASK;
 
                        if (enic_cq_rx_desc_ipv4_csum_ok(cqrd))
                                pkt_flags |= PKT_RX_IP_CKSUM_GOOD;
-                       else
+                       else if (mbuf->packet_type & RTE_PTYPE_L3_IPV4)
                                pkt_flags |= PKT_RX_IP_CKSUM_BAD;
 
                        if (l4_flags == RTE_PTYPE_L4_UDP ||