RXQ interrupts under Linux are based on the epoll mechanism. An
expected order of operations is as follows:
1. Call rte_eth_dev_rx_intr_enable(), to arm the CQ for receiving events
on data input.
2. Block on rte_epoll_wait() with an array of file descriptors
representing the CQ events. Upon data arrival the kernel will signal an
input event on the corresponding CQ fd.
3. Call rte_eth_dev_rx_intr_disable() after the event was received and
continue in polling mode. The mlx4 implementation of
rte_eth_dev_rx_intr_disable() is to get the CQ event and ack it.
In practice applications may wake up from rte_epoll_wait() due to
timeout with no event to ack but still call
rte_eth_dev_rx_intr_disable() unconditionally. In such cases the call
should return EAGAIN (since the file descriptors are non-blocked), as
opposed to EINVAL which indicates a real failure. In case of EAGAIN the
PMD should not warn on "unable to disable interrupt on rx queue".
Signed-off-by: Ophir Munk <ophirmu@mellanox.com>
Acked-by: Raslan Darawsheh <rasland@mellanox.com>
} else {
ret = mlx4_glue->get_cq_event(rxq->cq->channel, &ev_cq,
&ev_ctx);
- if (ret || ev_cq != rxq->cq)
+ /** For non-zero ret save the errno (may be EAGAIN
+ * which means the get_cq_event function was called before
+ * receiving one).
+ */
+ if (ret)
+ ret = errno;
+ else if (ev_cq != rxq->cq)
ret = EINVAL;
}
if (ret) {
rte_errno = ret;
- WARN("unable to disable interrupt on rx queue %d",
- idx);
+ if (ret != EAGAIN)
+ WARN("unable to disable interrupt on rx queue %d",
+ idx);
} else {
rxq->mcq.arm_sn++;
mlx4_glue->ack_cq_events(rxq->cq, 1);